Make the Embeds ONE: Cut the
Clear Melt and Pour into 1 inch cubes. In a heat-safe container, melt the soap
base on 30 second bursts, stirring between bursts until the soap is fully
melted.
TWO: Add 5 drops Liquid Green Colorant and optional 1 mL
Spearmint Essential oil and mix well.
THREE: Once the soap is between 125 - 135 degrees, pour into
the Guest Tree Mold. Spray with Rubbing Alcohol to eliminate bubbles and allow
to fully harden.
FOUR: Remove the soaps from the mold, and move on to the next step.
Exclusive for our newsletter subscribers: Use this
custom label template for our
Cube Boxes
which perfectly fit the Snow Globe Surprise Soap!
|
|
Make Snow Globes ONE: Cut the
White Melt and Pour into 1 inch cubes. In a heat-safe container, melt the soap
base on 30 second bursts, stirring between bursts until the soap is fully
melted.
TWO: With the top of the 4 Sphere Silicone Mold separated from
the base, pour the White Melt and Pour into the base of the mold. Split the soap
evenly between the four cavities. If necessary, use a clean-up tool to clean any
dribbles of soap on the sides of the mold.
THREE: Once the white soap has hardened, arrange the Christmas
trees, penguin, ducky and birdie in the sphere molds. Put the top back on the
mold temporarily in check the fit of the embeds. You may need to cut the
Christmas trees at the base to make them fit.
FOUR: Cut the Clear Melt and Pour into 1 inch cubes. In the
Easy Pour Measuring Cup, melt the soap base on 30 second bursts, stirring
between bursts until the soap is fully melted.
|
|
FIVE: Add 1/2 teaspoon Iridescent Glitter, 1/4 teaspoon Silver
Glitter, and the Spearmint Essential Oil and Christmas Forest Fragrance Oil. Mix
until fully incorporated.
SIX: Remove the top of the Sphere Mold. Spray all of the embeds
and the white soap liberally with Rubbing Alcohol. Check the temperature of the
clear soap; ensure that it is between 125 - 135 degrees, stir again, then pour a
1/4 inch layer into the sphere mold to secure the embeds. Spray again with
Rubbing Alcohol to remove bubbles.
SEVEN: Once the first layer of clear has fully hardened, replace the top on the 4 Sphere Silicone Mold. Spray inside the opening in the top of the mold with Rubbing Alcohol. Ensure that the temperature of the remaining clear soap is between 125-130 degrees, stir, and pour the final layer of soap into the sphere mold.
EIGHT: Allow the soap to fully harden. Unmold and enjoy!
|
|